EGW Remington 700 Short Action 20 MOA 40002

Remington 700 Short Action 20 MOA

20 MOA #40002

Picatinny Rail high tensile aluminium 159mm

Picatinny rail/also fits weaver style rings

This mount fits:
Remington 700 Short Action
Remington 700 Ultimate Muzzleloader
Remington 722 Short Action
Remington 40X Short Action

This mount is too low to work on the Remington 700 PCR and CP. Those applications will require the use of our EGW Hunter Series mounts (which we don't have, may be able to get with special order which is non refundable and payment up front).

Rail Type: One Piece Picatinny

Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: 3.627"
Overall Length: 6.276"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

This mount comes standard with a bevel on both sides making it ambidextrous.

The bolt pattern on our Remington 700 Short Action mount fits Short Action Remington 700 rifles (example 223, 308), as well as the 722 and 40x. Despite what you may have heard, the Remington 700 mount will NOT fit your Howa 1500 or Weatherby Vanguard. The bolt pattern is similar, but the remainder of the mount (ejection port, length, etc.) renders it useless on these two guns.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

We recommend:

0 MOA - if shooting 0-500 yards (0-457 meters)
20 MOA - if shooting 500-1000 yards (457-914 meters)

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards (182 meters).